The transmission gearbox is a gearbox that changes the transmission ratio and the direction of motion. between the clutch and the center drive. Today, I will talk to you about the maintenance method of the gearbox.

1. Check the gearbox in time

It is necessary to check the amount of oil in the gearbox in time to ensure that it is maintained within the specified range, and timely fill it according to the actual working conditions. When filling, it is necessary to ensure that the newly added oil is the same oil, and replace the oil. When the gearbox is working, it is necessary to release the previous oil in time and clean it. It is necessary to regularly check the working state of the gearbox gears to ensure that the meshing between the gears is in the best state, and clean up in time to ensure the perfect coordination between the gears and the shaft.

2. Check the status of different connection parts of the gearbox in time

During the daily maintenance process, it is necessary to check the status of each connection part of the gearbox, and find out in time whether there are looseness, wear and other faults. When the connection part is loose, it should be tightened in time, and the damaged part should be repaired and replaced in time. Check the shaft end face oil seal and the external joint part in time for oil leakage and oil leakage, and replace the failed oil seal and paper pad in time.

3. Maintenance of gearbox structural components

The daily maintenance of the gearbox should pay attention to the maintenance of the gearbox structural parts, and the maintenance of the gearbox gears, bearings and different shafts. It is necessary to promptly check whether the gearbox gears are worn, toothed, and meshing errors. To strengthen the inspection of the bearing, pay attention to problems such as excessive axial or radial clearance of the bearing and wear of the spacer. The internal structural parts of the gearbox should be properly maintained and inspected to ensure that they operate in the best state, and problems can be found and solved in time.

4. Develop good driving habits

In the process of daily use, it is necessary to develop good driving habits. When shifting gears, do not operate the shift lever too hard, and use prescribed methods to prevent damage to the gears, damage to the joystick fork, and damage to the joystick. When shifting gears, make sure that the clutch is fully depressed before operating the lever to prevent damage to the gears. During operation, the clutch should not be stepped on too quickly when shifting gears frequently, so as to prevent the transmission parts from being subjected to a large impact, which may cause the tooth surface to peel off or even the transmission splines to break. During transportation, the method of suddenly lifting the clutch pedal cannot be used to obtain a large driving force to overcome the trouble of large loads or obstacles, and reduce the wear caused by the impact of the gears.

I hope this content is helpful to you. We are a professional Hydraulic Power Units Wholesaler. If you want to know more professional information, please continue to pay attention to us.